ADA bathroom remodel in Los Angeles: what applies to a private home

By Home Pro Green Remodeling Inc. · Published November 16, 2026

Does a bathroom remodel in a Los Angeles home have to meet the ADA?

No. The ADA Standards apply to public accommodations and commercial facilities, and the U.S. Access Board says the ADA does not apply to individually owned or leased private housing, including single family homes, condominiums and apartments, unless part of the home is used as a public accommodation.1 In a private home, an "ADA bathroom" means using the ADA measurements as a planning guide, while the normal LADBS permit rules still apply to the work.13

Home Pro Green Remodeling Inc. is based in Tarzana and serves the San Fernando Valley and greater Los Angeles. The measurements below are from the published 2010 ADA Standards. They are a reference for planning a private bathroom, not a legal requirement for a home and not a Home Pro specification. Each bathroom's layout is confirmed on site.

What measurements do the ADA Standards use for a bathroom?

  • Turning space. A 60 inch diameter circle, or a T-shaped space within a 60 inch square (2010 ADA Standards section 304.3)
  • Clear floor space at a fixture. 30 by 48 inches minimum (2010 ADA Standards section 305.3)
  • Door opening. 32 inches clear minimum, measured with the door open 90 degrees (2010 ADA Standards section 404.2.3)
  • Toilet location. Centerline 16 to 18 inches from the side wall (2010 ADA Standards section 604.2)
  • Toilet seat height. 17 to 19 inches above the floor to the top of the seat (2010 ADA Standards section 604.4)
  • Sink or lavatory. Front of the rim or counter 34 inches maximum above the floor (2010 ADA Standards section 606.3)
  • Grab bars. Horizontal, 33 to 36 inches above the floor to the top of the gripping surface (2010 ADA Standards section 609.4)
  • Transfer type shower. 36 by 36 inches inside, with a 36 inch entry (2010 ADA Standards section 608.2.1)
  • Roll-in type shower. 30 inches wide by 60 inches deep inside, with a 60 inch entry (2010 ADA Standards section 608.2.2)

All figures are from the 2010 ADA Standards.2 The Standards let the clear floor spaces, fixture clearances and turning space overlap, and they say doors should not swing into the clear floor space required at a fixture, with listed exceptions.2

Which measurements usually set the layout?

The turning space and the shower size. A 60 inch circle and a 60 inch deep roll-in shower take the most floor area, while the 30 by 48 inch space at each fixture can overlap the turning space.2 Measure the room against those two first. If they do not fit inside the current walls, the plan either uses the smaller options listed above or moves a wall, and a wall change adds a plan check step in Los Angeles.3

Which bathroom changes need an LADBS permit?

  • Same layout, new finishes and fixtures. LADBS's combined e-permit covers repairing or replacing cabinets, flooring, wall finishes, tile, counters, and plumbing and electrical fixtures, with no change to walls or openings.3 LADBS lists a bathroom remodel with no structural changes as an Express Permit, with no plan check.4
  • Moving the toilet or adding a fixture in a wall. The e-permit does not allow new plumbing or electrical fixtures into existing walls. Those permits are issued at a LADBS center.3
  • Widening the door or moving a wall. A wall or opening change needs plan check at the public counter of a LADBS center, with two sets of floor plans at 1/4 inch to 1 foot showing the existing and proposed layout of the bathroom and each room next to it.3 LADBS says counter plan check is done the day the plans are submitted, about 45 to 60 minutes for small and medium projects.6
  • Inspection. In most cases one inspection is required when the bathroom work is complete, booked under code 335 Final.3

First confirm the address is in the City of Los Angeles with ZIMAS. If it is not, another department issues the permit.7

What does California require for grab bar reinforcement?

For newly constructed homes, the 2025 California Residential Code, Section R328.1.1, requires grab bar reinforcement in at least one bathroom on the entry level. It must be solid lumber no smaller than 2 by 8 inch nominal, or another approved material with equal height and load capacity, placed between 32 and 39 1/4 inches above the finished floor, flush with the wall framing, at the toilet, the shower and the tub.5

That section is written for new dwellings.5 In a remodel of an existing home, the same reinforcement can be added while the walls are open, so grab bars can go in later without opening the wall again. The ADA grab bar height of 33 to 36 inches falls inside that 32 to 39 1/4 inch band.25

What about condos and apartments?

The Access Board notes that many types of multifamily housing are subject to the design requirements of the Fair Housing Act.1 For work inside a condo unit, ask your HOA what approvals it requires before work starts, in addition to the LADBS permit.

How do you plan an ADA-style bathroom remodel?

  1. Measure the room against the measurements above, starting with the turning space and the shower.
  2. Decide what stays in place and what moves. Moving fixtures or walls changes the permit path.3
  3. Check the address in ZIMAS and confirm which permit applies.7
  4. Check your contractor's license on the CSLB Check a License page.8 Ours is 1003187. We pull the permits, and the contract should name who does.

Written by Home Pro Green Remodeling Inc., a general contractor in Tarzana with over 30 years of combined experience. CSLB #1003187.

Next step

Call (213) 770-6727 or use the contact form to talk about your kitchen or bathroom remodel. We will measure the room and tell you which permit path applies. Home Pro Green Remodeling Inc., CSLB #1003187.

Related reading

Home Pro Green Remodeling Inc. | CSLB #1003187 18375 Ventura Blvd Ste 378, Tarzana, CA 91356 (213) 770-6727

Sources (all pages opened and read on 2026-11-16)

  1. U.S. Access Board, Chapter 1: Using the ADA Standards (ADA coverage of housing: does not apply to individually owned or leased private housing, including single family homes, condominiums or apartments, not used as a public accommodation; multifamily housing and the Fair Housing Act). https://www.access-board.gov/ada/guides/chapter-1-using-the-ada-standards/
  2. ADA.gov, 2010 ADA Standards for Accessible Design (sections 304.3, 305.3, 404.2.3, 603.2, 604.2, 604.4, 606.3, 608.2.1, 608.2.2, 609.4). https://www.ada.gov/law-and-regs/design-standards/2010-stds/
  3. PermitLA (LADBS), Bathroom Remodel/Repair (combined e-permit scope, wall and opening changes, plans, shower and toilet rules, inspections, code 335 Final). https://www.permitla.org/building/bathroom_remodel_repair_detail.html
  4. LADBS Information Bulletin P/GI 2026-003, Express Permits (No Plan Check Required), effective Jan 1, 2026, revised Jun 10, 2026 (kitchen/bathroom remodel for residential buildings, no structural changes). https://dbs.lacity.gov/sites/default/files/efs/forms/pc17/ib-p-gi-2020-003-express-permits_rev-5-28-2024.pdf
  5. 2025 California Residential Code, Section R328.1 and R328.1.1, Reinforcement for Grab Bars (newly constructed dwellings), as published on UpCodes (a code publishing site, not a contractor). https://up.codes/viewer/california/ca-residential-code-2025/chapter/3/building-planning
  6. LADBS, Counter Plan Check (plans reviewed the day of submittal; small and medium projects in about 45 to 60 minutes; alteration to a single family dwelling listed). https://dbs.lacity.gov/services/plan-review-permitting/plan-check-permit/counter-plan-check
  7. LADBS, Homeowner Step-By-Step (ZIMAS check, CSLB licensing, inspections). https://dbs.lacity.gov/services/homeowner-step-by-step
  8. CSLB, Check a License. https://www.cslb.ca.gov/onlineservices/checklicenseII/checklicense.aspx

Frequently asked questions

Does the ADA apply to a single family home in Los Angeles?

No. The U.S. Access Board says the ADA does not apply to individually owned or leased private housing, including single family homes, unless part of the home is used as a public accommodation.

What is the ADA turning space for a bathroom?

A 60 inch diameter circle, or a T-shaped space within a 60 inch square.

How high are ADA grab bars?

Horizontal, 33 to 36 inches above the finished floor, measured to the top of the gripping surface.

Do I need a permit to widen a bathroom door in Los Angeles?

Yes. A wall or opening change needs plan check at the public counter of a LADBS center, with existing and proposed floor plans.

How do I check a contractor's license?

On the CSLB Check a License page. Ours is 1003187.

Ready to see what your home could be?

A free in-home visit. We come to you, look at the space, and give you straight answers. Financing available.

Call (213) 770-6727
Call